Please email can also check out the Processing Documentation and Support page for a wide range of information including help with reflow solder, wave soldering, solder locks, cleaning, and more. Have a question about a Samtec product, and which class it would meet in IPC-A-610? We are here to help answer that question. With your certification, you can demonstrate to clients and employers that you understand the quality requirements necessary for building reliable electronic assemblies.
An IPC-A-610 Certification conveys that you have knowledge of, and conform to, industry standards when it comes to soldering components. Here at Samtec we are always focused on ways to be a service leader in this industry, and assisting customers with processing questions is no different. The Importance of IPC-A-610 Certification. If you made it this far, then clearly you are interested in the topic, and want some additional information. Depends on what class you are building too, 1.
Ipc 610 manual manual#
While this may not seem to be a huge increase, it does add to the difficulty of producing a conforming product. Your IPC-610 workmanship manual will have the answer for you (I dont have the latest at my fingertips). The side overhang is lowered to a 25% maximum of the width of the lead (4), and end joint thickness (3) is increased to a minimum of 75% of the lead width (4). The solder thickness (5) requirement remains “not specified,” and the side joint length (6) are the same as Class 2, but many of the other specifications have increased requirements.įor instance the side overhang (2) and end joint width (3), are tightened in both directions by 25%. Manual, IPC-A-610 (current revision), AJ-820A and a CD-ROM which includes certification and recertification visual presentations and IPC-A-610 Instructor Guide for training Certified IPC Specialists. Mil / Aero and Medical applications typically require Class 3 products.Ĭlass 3 increases the requirements in most areas of inspection for the solder joint over Class 2. DSP, Network, RF, Analog Design, PCB, Service Manuals.
Ipc 610 manual pdf#
Many of Samtec’s products can meet IPC-A-610 Class 3 which is normally required when a product must have continued high performance in extreme / harsh conditions. IPC-610 request I would appreciate if someone can send me the pdf file. The side joint length (6) of the solder joint, at the narrowest point, must be at least 150% the width of the lead (4). The solder thickness (5) between the lead and the pad landing is not specified, but a properly wetted fillet must be present.
0 kommentar(er)
